Yeah a flowmaster. Was wondering if anybody can tell me if this is crap or a pretty good system. Found a place to sell it under 200 bucks, and it promised 10-15 hp increase w 26lb of torque. What do you all think?

 

I've been looking for a place that sells this system since I got my rex. However, I'm supposed to buy an HKS cat back tomorrow. Mind telling me where you found it?

 

nevermind i supposed its here...
http://www.planetperformance.com/pro...PREZA&sf4=2.0L



let me know how it works out for you

 

That is a pretty cheap price for an exhaust, but look at the diameter of the piping 2.25 inches. That can't be much bigger than stock, and the only gains you may see are from a freer flowing muffler and straighter pipes. Piping this size could really limit you if you decide on modding more down the road.

 

But for $200.00 how could you complain

 

Hello,

I purchased a Flowmaster axle back system for my 02 WRX from my local Meineke shop.

Installation was a snap, but the fit of the system was actually very poor. It ended up rubbing on some of the heat shielding. I took it back to the Meineke guys and they agreed that the fit was not very good. I contacted Fowmaster and they thought that maybe I got a bad one (not put in the jigs properly).

I personally didn't like the sound of the Flowmaster on my WRX. Don't know how to explain it. The butt dyno didn't register any performance gains.

In the end I returned the unit and put an APS turbo-back on.

Burt

 

I recently purchased the Flowmaster system from Planetperformance. Despite what the ad says, it is only an axle-back, not a cat-back.

That said, I did notice a little improvement in performance. However, it is nowhere near what their website states. I have no idea where they got that info.

The sound is fantastic. Sounds almost like a small V8 rather than a 4-banger.

I have not had any problems with rubbing so I think burt_poppenga must have gotten a bad one.

Sound Clip Here

Please ignore the trailer hitch in the photos.