I bought a used set of brembo rears for another project, and I found out a bolt does not go through one of the holes of a caliper. Looking at it closer, the hole was previously helicoiled improperly. The bolt threads in at an angle and gets stuck. Does anyone know of a shop in sf that will re-helicoil it?

 

What size is the helicoil? You may need to clean up the threads too...

 

I'm not sure what's the size other than it uses the factory thread pitch.

 

Lic motorsports

 

I was hoping to find a place in sf so I don't have to take time off from work. I will definitely try lic if I can't find any.

 

Lemme know where you end up going. I gotta do my brembos too

 

it is an easy diy

 

Got it done at static nine garage in San Bruno.

 

 

Super easy, just get the kit for the size bolt you need.