Anyone have any experience using Lamin-X films?
Thread Starter
Something Custom
iTrader: (9)
Joined: Aug 2003
Posts: 14,505
From: Las Vegas NV
Car Info: 2018 Grand Cherokee Limited Ecodiesel EOC Stage 1
Anyone have any experience using Lamin-X films?
any pro's or cons? i found a set for my Audi covering both headlights and foglights for 39.99. Is it worth it?
Registered User
iTrader: (25)
Joined: Jan 2004
Posts: 2,325
From: san francisco
Car Info: 2008 Forester XT 5spd
Thread Starter
Something Custom
iTrader: (9)
Joined: Aug 2003
Posts: 14,505
From: Las Vegas NV
Car Info: 2018 Grand Cherokee Limited Ecodiesel EOC Stage 1
Registered User
iTrader: (6)
Joined: Oct 2006
Posts: 11,892
From: Hangin in Placerville youtube.com/rallydude1515
Car Info: 1999 RS Coupé- 1995 Mazda Miata -KTM 300
whoa whoa...so you go from Subaru L 1.8 FWD...Saturn that was loud as F...To this nice *** audi?!
BALLLLLLLLLLLIN!
BALLLLLLLLLLLIN!
Registered User
iTrader: (25)
Joined: Jan 2004
Posts: 2,325
From: san francisco
Car Info: 2008 Forester XT 5spd
Too bad you didn't wait a little longer:
http://sfbay.craigslist.org/pen/car/562689398.html
I used to have an 1998 A4 1.8T Quattro. Fun ride! Congrats (belated)! What happened to the Saturn?
http://sfbay.craigslist.org/pen/car/562689398.html
I used to have an 1998 A4 1.8T Quattro. Fun ride! Congrats (belated)! What happened to the Saturn?
I got lamin-x. Install was pretty much straight forward, just need a friend to help you. You need a hair dryer and spray bottle to make things much easier. What I got was gunsmoke.
Last edited by kyle sti; Feb 6, 2008 at 02:17 PM.
Thread Starter
Something Custom
iTrader: (9)
Joined: Aug 2003
Posts: 14,505
From: Las Vegas NV
Car Info: 2018 Grand Cherokee Limited Ecodiesel EOC Stage 1
now this is the kind of answer im looking for. what all is entailed in the installation process?
basically you clean the headlights. then you spray a mist of water (i used soapy water), peel the headlight film and hold from the tabs. then you align it straight. spray a mist over it then work your way out using the applicator card thing (make sure you keep spraying water over it so you don't scratch the film). use a hair dryer to get rid of air bubbles/water pockets and it will even mold better when its hot. after you're done just use an exacto knife to cut the tabs off.


