CEL P0130 what???
04-22-2003, 12:09 PM
#1
Registered User
Thread Starter
Join Date: Jan 2003
Location: Colorado
Posts: 144
Car Info: 2000 2.5 RS USDM STI block, SOHC heads GT25 Ball bearing turbo, TMIC, TXS BOV, Tial wastgate, etc...
CEL P0130 what???
I keep throwing this code, and my car is still running like crap.. I know the code is for malfunctioning O2sensor bank one, sensor one... what does this mean.. I have a new O2 sensor also.
04-22-2003, 10:17 PM
#2
Guest
Posts: n/a
code problem
I have seen aftermarket O2 sensors have different values, if that is what you used. There are so many variables with a run problem, is this the only code, did you clear the codes after installation of new O2? If you did, how many heat cycles did the car go thrugh before the code came back or did it show up as soon as the motor fired? Not knowing what you are working on, that's about all I can tell you now. With more info maybe I can help
04-23-2003, 06:56 PM
#3
Registered User
Thread Starter
Join Date: Jan 2003
Location: Colorado
Posts: 144
Car Info: 2000 2.5 RS USDM STI block, SOHC heads GT25 Ball bearing turbo, TMIC, TXS BOV, Tial wastgate, etc...
it is a subaru wide band O2 sensor, not an aftermarket sensor.. The code comes on when i let the car idle for about 5 minutes, or it will turn off and then come back on, while i am driving under normal conditions.. this is the only code that I am pulling, and yes I have cleared the codes.
Thread
Thread Starter
Forum
Replies
Last Post
MaVz
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
06-16-2004 09:41 PM
esracer
Engine/Power - EJ20T (pre-2006 WRX and JDM)
4
03-16-2004 11:56 AM
codger
Engine/Power - non turbo (All non turbo Imprezas)
1
07-20-2003 07:56 PM
NeVzWRX
Engine/Power - EJ20T (pre-2006 WRX and JDM)
10
06-23-2003 11:38 AM
