Some may have noticed that I just had a thread with similar headers for sale, well I did, they were Gruppe-S Unequal length headers. They have sold and now I'm selling the Equal length headers that I was going to put on the foz untill I realized that the oil pan would have to be swapped out with the STI unit. Instead of swapping all that out I ended up going with the WBR EL header that works with all the oil pan setups. So the foz will sit in the garage untill the WBR's show up.

Anyways, onto the subject matter. I purchased these from a member on NASIOC just a couple weeks ago. After recieveing them, I ported and gasket matched the inlet holes that mate up to the block. There is no longer a step when the exhaust exits the ports. I also cleaned up inside and around the flange that connects to the uppipe. I then wrapped them with Thermo-tec exhaust which has the highest temperature rating. It looks so good that I wish I could just bolt it up.

Also available with the header or seperate is a Turbo XS uppipe that I have also wrapped and coated. I dont have pictures of it yet since its still on the car, for now.

Header SOLD

Uppipe SOLD

PM with any questions.

Pictures

Here are a couple of videos that sold me on the EL setup:
Video
WBR clips

**fitment notes**
These will fit 04-07 STI's and LGT's without any modification. Foresters and WRX models require the STI style oil pan.

 

bump

 

friday bump

 

where in Nor Cal are you? Im interested.

 

I'm in the Sacramento area.

 

Header SOLD, Uppipe still available