My need HU with Legacy Din pocket
#1
Registered User
Thread Starter
iTrader: (1)
Join Date: May 2003
Location: San Diego, CA
Posts: 454
Car Info: 04 WRX
My need HU with Legacy Din pocket
Took me less than an hour to install. The only complaint is that when the DIN door is open it hits the HU when it is on. But that is just a minor set back. LOL
#6
Registered User
Thread Starter
iTrader: (1)
Join Date: May 2003
Location: San Diego, CA
Posts: 454
Car Info: 04 WRX
Damn! I think i should have gotten the forester DIN pocket lol. Oh well i can get it at a later time. Maybe down the road i can hide the boost control and turbo timer in the DIN pocket hehehehehe.
#9
Re: part number
Originally posted by holdtight
What is the part number for the forester DIN pocket?
What is the part number for the forester DIN pocket?
item 66128SA040 $18.68
#10
What about switching???
I haven't done this yet (since my 04 hasn't even F%$#@%& arrived yet), but I also plan to change out the factory 6 cd/cassette radio for a Kenwood CD/MP3 player.
My question is can you rearrange the unit so that the head unit is below and the din pocket is on top? Wouldn't that help with the parts bumping into each other when you try to open the din unit?
Also, is the Forester din pocket an easy fit or do you have to mod it also?
-C
My question is can you rearrange the unit so that the head unit is below and the din pocket is on top? Wouldn't that help with the parts bumping into each other when you try to open the din unit?
Also, is the Forester din pocket an easy fit or do you have to mod it also?
-C
#14
Guest
Posts: n/a
Re: Re: part number
Much appreciated!
#15
Guest
Posts: n/a
Folks,
I spent part of the past weekend installing my 'old' HU into my '02 WRX. I got the din pocket as well to cover the hole, and to give me more storage. I installed the pocket on top, and the HU on the bottom. However, when I tried to reinstall the beauty trim, I found that the pocket was sticking too far out! I have it inset as far as it'll go. Looking at the hole arrangement on the brackets, I may have to switch the HU and the pocket. Did anyone else run into this problem?
P.S. I wanted the HU on the bottom so that the cup holder would not cover the HU controls.
I spent part of the past weekend installing my 'old' HU into my '02 WRX. I got the din pocket as well to cover the hole, and to give me more storage. I installed the pocket on top, and the HU on the bottom. However, when I tried to reinstall the beauty trim, I found that the pocket was sticking too far out! I have it inset as far as it'll go. Looking at the hole arrangement on the brackets, I may have to switch the HU and the pocket. Did anyone else run into this problem?
P.S. I wanted the HU on the bottom so that the cup holder would not cover the HU controls.