LTS: GC8 Stuff
03-30-2014, 03:11 AM
#24
Photo Update 1
Dixcel Brake kit with pads and 4 pot fronts. SOLD
LH air duct for V2/3 front bumper
V2 STI gauge cluster
Suspention tops from unknown
Middle piece for V4 and newer
Stereo holder and sig drawer with extra drawer below for a V3 or older
V3 RA IC sprayer reservoir x2 with pump attached. this goes where the ABS goes next to intake
Intake hose.
amber side lights wraped in plastic. SOLD
Wiring harness in the box as well as spread out in another photo
Greddy Boost analog gauge. Bar
Steering column under piece for GC8
Engine Trim for GC8. SOLD
JDM white and red tails wrapped in bubble wrap. SOLD
TD04L turbo from 2002 Forester
JBL 12inch subwoofer SOLD
AC pump from Impreza wrapped in plastic next to turbo
One clear type fog light. Right side when looking at the front
Door Card for V3 or older STI
Stock intake for GC8 has filter
More intake pieces next to intake filter box.
Stock Radiator Hoses(i have a radiator too) Does not fit newer than 98(I tried...)
Seat Trim pieces for GC8, the ones that cover the bolts of the stock seats
LH air duct for V2/3 front bumper
V2 STI gauge cluster
Suspention tops from unknown
Middle piece for V4 and newer
Stereo holder and sig drawer with extra drawer below for a V3 or older
V3 RA IC sprayer reservoir x2 with pump attached. this goes where the ABS goes next to intake
Intake hose.
amber side lights wraped in plastic. SOLD
Wiring harness in the box as well as spread out in another photo
Greddy Boost analog gauge. Bar
Steering column under piece for GC8
Engine Trim for GC8. SOLD
JDM white and red tails wrapped in bubble wrap. SOLD
TD04L turbo from 2002 Forester
JBL 12inch subwoofer SOLD
AC pump from Impreza wrapped in plastic next to turbo
One clear type fog light. Right side when looking at the front
Door Card for V3 or older STI
Stock intake for GC8 has filter
More intake pieces next to intake filter box.
Stock Radiator Hoses(i have a radiator too) Does not fit newer than 98(I tried...)
Seat Trim pieces for GC8, the ones that cover the bolts of the stock seats
Last edited by Subie-Mes; 01-17-2015 at 11:02 PM.
03-30-2014, 03:26 AM
#25
Photo Update 2
In these photos:
Door trim behind mirrors
Window motor
Clear JDM passanger side clear head lamp
Brake master cylinder impreza
battery Tray
Bearing kit. unused. I just wrapped it in plastic with label
Gas door WHite SOLD
Forester intake pieces to include maf
Impreza RHD ECU cover
More corner lights amber SOLD
V5/6 bumper amber corner turn signal lights
My one of 2 OEM subaru labeled Foglights SOLD
Various Lights. I have a lot of lights for fog, rear, side and headlamp
MAF for 04 impreza can go with wire harness
ECU for EJ20K
Rear LED light
Ram intake shroud. no mount
Stock V4 or older bumper license plate mount with screws
V3 and older type R/RA rear IC spray reservoir. I have 2 of these.
Gray STI V3 or older bumper fog light caps. SOLD
Brake booster used as well as a Brake master cylinder that came with it.
2 pot RHD gauge pod holder for GC8 only
GC8 V4 headers SOLD
JDM subaru tool bag numbered for a 97 impreza. This one was #50 made that year.
Used Timing belts. low miles on them but if you want those come get them and ill just give them to you.
Various EJ20 DOHC belt covers from various EJ20 engines. all same. i have 2 sets
i have 3 alternators. 1 is from the forester so fit that kind of clip. the other 2 are from GC8 V4 or older
Various engine mounts can be used for Alternator flips if you go that route. i have 2 for that.
I have both front belts that i had just replaced before stripping the engine. They are new from Japan. Used for 200~ Km
Coolent reservoir came from EJ20T
Door trim behind mirrors
Window motor
Clear JDM passanger side clear head lamp
Brake master cylinder impreza
battery Tray
Bearing kit. unused. I just wrapped it in plastic with label
Gas door WHite SOLD
Forester intake pieces to include maf
Impreza RHD ECU cover
More corner lights amber SOLD
V5/6 bumper amber corner turn signal lights
My one of 2 OEM subaru labeled Foglights SOLD
Various Lights. I have a lot of lights for fog, rear, side and headlamp
MAF for 04 impreza can go with wire harness
ECU for EJ20K
Rear LED light
Ram intake shroud. no mount
Stock V4 or older bumper license plate mount with screws
V3 and older type R/RA rear IC spray reservoir. I have 2 of these.
Gray STI V3 or older bumper fog light caps. SOLD
Brake booster used as well as a Brake master cylinder that came with it.
2 pot RHD gauge pod holder for GC8 only
GC8 V4 headers SOLD
JDM subaru tool bag numbered for a 97 impreza. This one was #50 made that year.
Used Timing belts. low miles on them but if you want those come get them and ill just give them to you.
Various EJ20 DOHC belt covers from various EJ20 engines. all same. i have 2 sets
i have 3 alternators. 1 is from the forester so fit that kind of clip. the other 2 are from GC8 V4 or older
Various engine mounts can be used for Alternator flips if you go that route. i have 2 for that.
I have both front belts that i had just replaced before stripping the engine. They are new from Japan. Used for 200~ Km
Coolent reservoir came from EJ20T
Last edited by Subie-Mes; 01-17-2015 at 11:03 PM.
03-30-2014, 03:42 AM
#26
Photo Update 3
In these Photos:
2002 JDM ECU from Forester
Closer photos of the different type of alternators. all worked fine. No issues there
Euro Spec tails with wiring
DEPO clear corners
More radiator hoses.
GC8 or Forester Spark Wires
OEM battery holder
Hood spayer hosing with filter and one way valve in the piping
OEM WRX Oil Cooler
OEM Thermostate unused and in the box still
HKS BOV plug. The BOV is in one of the photos above but it is wrapped in plastic. It has all the hosing to go from the Intercooler
2002 JDM ECU from Forester
Closer photos of the different type of alternators. all worked fine. No issues there
Euro Spec tails with wiring
DEPO clear corners
More radiator hoses.
GC8 or Forester Spark Wires
OEM battery holder
Hood spayer hosing with filter and one way valve in the piping
OEM WRX Oil Cooler
OEM Thermostate unused and in the box still
HKS BOV plug. The BOV is in one of the photos above but it is wrapped in plastic. It has all the hosing to go from the Intercooler
Last edited by Subie-Mes; 08-08-2014 at 10:07 PM.
