Hello all! I recently did some work to my '02 WRX. Included in this was the replacement of the front seats. My question right now is what do I do to get rid of the airbag warning light that comes on? Thanks in advance!

Tim

try re-setting your ECU:

do while engine is stone cold:

leave negative terminal off for 10 min.

reconnect battery.

turn key to on positon (make sure all accessories are all turned off)

wait till engine fans turn on, and then turn off

turn key to off position

you're done!

I hope it works, but make sure you re-connected the wires for the side airbags, which are part of the seats.

Wait, did you install JDM seats??

If so, they don't have the airbags and this could be causing the problem...

also, wrong forum

need to put it resistors, very easy, you can get them from radio shack, i did the same to my sti when i put my sparcos in

what kind of resistiors? Does it even matter?

i believe 3ohm 1 watt, you can find out though, your going to want to reuse the plastic plug on the end of the wires on the stock seats, so tat you can put the resistors in the plug , which makes it easier

i have jic seats- i live with the airbag light...
too lazy to fix the ABL. plus my friend has my STi seats.





aloha from the summit of *-^-Mauna Kea-^-*