Alright, I am working on making a custom gauge pod for my Defi link system, will have 3 - 60mm slots and a spot for the controler, but now I need to figure out the best way to mount this thing to the center of the dash, where the stock clock was.

So, if any of you have any pictures of the bottom of your guage pods that fit into the center of the dash that you could post up, i'd appreciate it.

-Kevin

 

Defi makes a pod that fits there. Its ugly (sorry Tommy ), but it works. There are others, and a few JDM ones that point the wrong way, heh.

jason

 

Here is my creation.

Defi all the way!

 

imprezer> oooh, the defi control unit fits right in beside the cupholder? i've been wanting to get the link display unit, but not sure where to mount it. slick cluster, btw!

 

Actualy I am trying to get a picture like this;



That is from my friends mr2 though, and his car does not have clips like ours do, I wanted to see how these gauge pods for our cars were doing it.

Also I already have my turbo timer mounted next to the cup holder. And that is why I wanted the control unit in the gauge pod itself.

 

The link unit does fit.

I needed to trim the cup holder by about 1/4" so that it would still open. Also, the side of the link unit needed to be trimmed so that it wouldnt hit the inside of the cupholder, since it sits at an angle.